How To Proceed With Troubleshooting [08/2013 - ]

HINT: 

• Use the following procedures to troubleshoot the power tilt and telescopic steering column system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

3. CHECK CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.
      RESULT
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

      B → Go to  CAN COMMUNICATION SYSTEM 

      A: Go to next step 

4. CHECK FOR DTC* 
   1. Check for DTCs. Refer to DTC CHECK / CLEAR [08/2013 - ] .
   2. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2013 - ] .
   3. Recheck for DTCs. Refer to DTC CHECK / CLEAR [08/2013 - ] .
      RESULT
      
      

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

      B → Go to  DIAGNOSTIC TROUBLE CODE CHART [08/2013 - ]  

      A: Go to next step 

5. PROBLEM SYMPTOMS TABLE 
   RESULT
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B → Go to step 8 

   A: Go to next step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Terminals of ECU. Refer to TERMINALS OF ECU [08/2013 - ] 
   2. Data List/Active Test. Refer to DATA LIST / ACTIVE TEST [08/2013 - ] 

      NEXT: Go to next step 

7. REPAIR 

   NEXT: Go to next step 

8. CONFIRMATION TEST 

   NEXT → END