DTC U1119: Lost Communication with Object Recognition ECU (CAN); DTC U1119: Lost Communication with Object Recognition ECU (Serial); DTC U1120: Lost Communication with Object Recognition Camera [10/2014 - ]: Procedure

1. Using the Techstream, enter the following menus: Powertrain / Radar Cruise / Data List.
   RADAR CRUISE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Communication with Object Recognition ECU	Communication with object recognition ECU signal/AVAIL or FAIL	AVAIL: Communication is normal FAIL: Communication is malfunctioning	-

2. Check the condition of the "Communication with Object Recognition ECU" Data List item.

   HINT: 

   As the "Communication with Object Recognition ECU" item monitors the CAN communication condition, distinguishing between a CAN communication malfunction and serial communication malfunction is possible. If a CAN communication malfunction may be present, proceed to the DIAGNOSTIC TROUBLE CODE CHART.

   RESULT
   
   

   Result	Proceed to
   "Communication with Object Recognition ECU" is "AVAIL"	A
   "Communication with Object Recognition ECU" is "FAIL"	B

B → See step   9 

A: Go to next step 

1. Disconnect the p1 ECU connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disconnect the X17 camera connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   p1-12 (SGND) - X17-12 (SGND)	Always	Below 1 Ω
   p1-13 (RX) - X17-14 (TX)	Always	Below 1 Ω
   p1-14 (TX) - X17-13 (RX)	Always	Below 1 Ω
   p1-13 (RX) - Body ground	Always	10 kΩ or higher
   p1-12 (SGND) - Body ground	Always	10 kΩ or higher
   p1-14 (TX) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Replace the object recognition camera. Refer to REMOVAL [10/2014 - ] .

NEXT: Go to next step 

1. Adjust the object recognition camera. Refer to ADJUSTMENT [10/2014 - ] .

NEXT: Go to next step 

1. Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Code.
2. Select "Clear" and clear the data.
3. Based on the DTC detection conditions, try to simulate the malfunction.
4. Recheck for DTC.

   OK

   DTCs U1119 and U1120 are not output.

NG → See step   6 

OK → END (OBJECT RECOGNITION CAMERA IS DEFECTIVE) 

1. Replace the object recognition ECU. Refer to REMOVAL [10/2014 - ] .

NEXT: Go to next step 

1. Adjust the object recognition camera. Refer to ADJUSTMENT [10/2014 - ] .

NEXT: Go to next step 

1. Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Code.
2. Select "Clear" and clear the data.
3. Based on the DTC detection conditions, try to simulate the malfunction.
4. Recheck for DTC.

   OK

   DTCs U1119 and U1120 are not output.

NG → See step   10 

OK → END (OBJECT RECOGNITION ECU IS DEFECTIVE)