LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> LS 460 Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostic Codes P0340-P1366) >> SFI System >> DTC P0705: Transmission Range Sensor Circuit (PRNDL Input) [10/2014 - ] >> Inspection Procedure

Inspection Procedure

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.
    2. Turn the engine switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the engine switch on (IG).
    5. Turn the Techstream on.
    6. Enter the following menus: Powertrain / Engine / Data List / All Data /
    7. According to the display on the Techstream.
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Shift SW Status (R Range) PNP switch status/
      ON or OFF
      • Shift lever in R: ON
      • Shift lever not in R: OFF
      		 When shift lever position displayed on the Techstream differs from actual position, adjustment of PNP switch or shift cable may be incorrect
      Shift SW Status (P Range) PNP switch status/
      ON or OFF
      • Shift lever in P: ON
      • Shift lever not in P: OFF
      		 When shift lever position displayed on the Techstream differs from actual position, adjustment of PNP switch or shift cable may be incorrect
      Shift SW Status (N Range) PNP switch status/
      ON or OFF
      • Shift lever in N: ON
      • Shift lever not in N: OFF
      		 When shift lever position displayed on the Techstream differs from actual position, adjustment of PNP switch or shift cable may be incorrect
      Shift SW Status (D Range) PNP switch status/
      ON or OFF
      • Shift lever in D, M or S: ON
      • Shift lever not in D, M or S: OFF
      		 When shift lever position displayed on the Techstream differs from actual position, adjustment of PNP switch or shift cable may be incorrect
      Sports Mode Selection SW Sport Mode Select Switch Status/
      ON or OFF
      • Shift lever in M (or S), "+" or "-": ON
      • Shift lever not in M (or S), "+" or "-": OFF
      		 -
scientia non olet · About LEMON Manuals