Display does not Dim when Light Control Switch is Turned ON [10/2014 - ]: Procedure
- CHECK IMAGE QUALITY SETTING
- Display the "Display" screen.
- Turn the light control switch to the tail or head position.
- Check if "Day Mode" on the display adjustment screen is on.
OK
"Day Mode" setting is off
NG → TURN "Day Mode" SETTING OFF
OK: Go to next step
- CHECK VEHICLE SIGNAL (OPERATION CHECK)
- Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check. Refer to OPERATION CHECK [10/2014 - ]
]
- Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.
OK
Light Control Switch Display Tail or head ON Off OFF HINT:
This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.
- Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the light control switch operation.
OK
Light Control Switch Display Tail or head DIM Off BRIGHT
NG → See step 3
OK → See step 4
- Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check. Refer to OPERATION CHECK [10/2014 - ]
]
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [10/2014 - ]
- REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY. Refer to REMOVAL [10/2014 - ]