LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> IS 250C Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Control System (Diagnostic Codes (P0190-P062F)) >> SFI System >> DTC P060E: Internal Control Module Throttle Position Performance [08/2013 - ] >> Procedure

DTC P060E: Internal Control Module Throttle Position Performance [08/2013 - ]: Procedure

  1. READ OUTPUT DTC (DTC P060E) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2013 - ] .
    5. Turn the Techstream off.
    6. Turn the engine switch off.
    7. Disconnect the Techstream.
    8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
    9. Connect the cable to the negative (-) battery terminal.
    10. Connect the Techstream to the DLC3.
    11. Turn the engine switch on (IG).
    12. Turn the Techstream on.
    13. Wait for 16 seconds or more.
    14. Enter the following menus: Powertrain / Engine / Trouble Codes.
    15. Read the DTCs.

      Result

      Result Proceed to
      DTC is not output A
      DTC P060E is output B

    B → See step   3 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [08/2013 - ] 
  3. REPLACE ECM. Refer to  REMOVAL [08/2013 - ] 
scientia non olet · About LEMON Manuals