Removal [08/2013 - ]
- PRECAUTION NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work. Refer to PRECAUTION [08/2013 - ] .
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .
- REMOVE DOOR SCUFF PLATE ASSEMBLY RH . Refer to REMOVAL [08/2013 - ] - Step 7
- REMOVE COWL SIDE TRIM BOARD RH . Refer to REMOVAL [08/2013 - ] - Step 9
- REMOVE INSTRUMENT PANEL FINISH PANEL END RH . Refer to REMOVAL [08/2013 - ] - Step 6
- REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to REMOVAL [08/2013 - ] - Step 2
- REMOVE INSTRUMENT LOWER COVER LH . Refer to REMOVAL [08/2013 - ] - Step 29
- REMOVE NO. 2 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY . Refer to REMOVAL [08/2013 - ] - Step 7
- REMOVE INSTRUMENT SIDE PANEL RH . Refer to REMOVAL [08/2013 - ] - Step 26
- REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH . Refer to REMOVAL [08/2013 - ] - Step 27
- REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY . Refer to REMOVAL [08/2013 - ] - Step 28
- REMOVE INSTRUMENT PANEL BOX DOOR COVER . Refer to REMOVAL [08/2013 - ] - Step 31
- REMOVE INSTRUMENT PANEL BOX ASSEMBLY . Refer to REMOVAL [08/2013 - ] - Step 32
- REMOVE DRIVING SUPPORT SWITCH CONTROL ECU
- Disconnect the connector.
- Remove the bolt and driving support switch control ECU.