Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter [08/2014 - ]: Procedure
- CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
- Disconnect the H98 multi-media module receiver assembly connector.
- Disconnect the H181 No. 1 stereo jack adapter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition H98-6 (VV+) - H181-8 (VV+) Always Below 1 Ω H98-14 (VV-) - H181-9 (VV-) Always Below 1 Ω H98-6 (VV+) - Body ground Always 10 kΩ or higher H98-14 (VV-) - Body ground Always 10 kΩ or higher H98-13 (SG) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2014 - ]