DTC C1691: Back Camera Initialization Incomplete [08/2014 - ]: Procedure

1. Perform the following procedure depending on the memory conditions to register the vehicle information into the multi-media module receiver assembly.
   1. Rear television camera assembly optical axis adjustment (back camera position setting). Refer to CALIBRATION [08/2014 - ] .

NEXT: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2014 - ] .
2. Recheck for DTCs and check that no DTCs are output. Refer to DTC CHECK / CLEAR [08/2014 - ] .

   HINT: 

   • If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment (back camera position setting) again.
   • If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the multi-media module receiver assembly.

   Result

   Result	Proceed to
   DTC C1691 is output	A
   DTC C1691 is not output	B

B → END 

A → See step   3