All Door Entry Unlock Functions except Driver Door do not Operate [08/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Customize Setting / Smart Key/Access.
5. Check the customize setting.
   SMART KEY/ACCESS
   
   

   Display	Default	Content	Setting	Relevant ECU
   Door Unlock Mode2	Driver	Function that chooses the doors to be operated by entry unlock operation.	All or Driver	Certification ECU (smart key ECU assembly)

   Result

   Result	Proceed to
   "Driver" is selected.	A
   "All" is selected.	B

B → See step   4 

A: Go to next step 

1. Select "All" for the customize setting.

   Result

   Result	Proceed to
   "All" can be selected.	A
   "All" cannot be selected.	B

B → See step   7 

A: Go to next step 

1. Check that the entry unlock functions operate normally. Refer to OPERATION CHECK [08/2014 - ] .

   OK

   Entry unlock functions operate normally.

NG → See step   4 

OK → END (DIFFERENT CUSTOMIZE SETTING ITEM WAS SELECTED) 

1. Check if the power door lock control system operates properly for doors other than the driver door. Refer to OPERATION CHECK [08/2014 - ] .

   HINT: 

   Make sure to check doors one by one.

   OK

   The power door lock control system operates properly for doors other than the driver door.

NG → See step   8 

OK: Go to next step 

1. Temporarily replace the certification ECU (smart key ECU assembly) with a new one.

   HINT: 

   • For replacement. Refer to REMOVAL [08/2014 - ] .
   • For registration. Refer to REGISTRATION [08/2014 - ] .

NEXT: Go to next step 

1. Check that the entry unlock functions operate normally. Refer to OPERATION CHECK [08/2014 - ] .

   OK

   Entry unlock functions operate normally.

NG → See step   9 

OK → END (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) WAS DEFECTIVE)