LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> LS 460 Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Rear View Monitor System (Diagnostics) (Introduction) >> Rear View Monitor System >> DTC Check / Clear [09/2013 - ] >> DTC Check / Clear [09/2013 - ]

DTC Check / Clear [09/2013 - ]

  1. CHECK FOR DTC (USING TECHSTREAM) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
    5. Check for DTCs.
      NOTE:

      The multi-media module receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the multi-media module receiver assembly are output, refer to Diagnostic Trouble Code Chart for the relevant system.

      System Proceed to
      Navigation system Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2013 - ]
      Audio and visual system Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2013 - ]
      Rear seat entertainment system Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2013 - ]
  2. CLEAR DTC (USING TECHSTREAM) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
    5. Clear the DTCs.
  3. CHECK DTC (USING DIAGNOSTIC MODE) 
  4. CLEAR DTC (USING DIAGNOSTIC MODE) 
scientia non olet · About LEMON Manuals