DTC C2141/41: Transmitter ID1 Error; DTC C2142/42: Transmitter ID2 Error; DTC C2143/43: Transmitter ID3 Error; DTC C2144/44: Transmitter ID4 Error [09/2013 - ]: Description
The tire pressure warning valve and transmitter installed in each tire and wheel assembly measures the tire pressure. The measured values are transmitted as radio waves to the tire pressure warning antenna on the body and then set to the tire pressure warning ECU and receiver. The ECU compares the measured air pressure values with the air pressure threshold. When the measured air pressure value is less than this threshold, the warning light in the combination meter assembly comes on. The tire pressure warning ECU stores a DTC when a tire pressure warning valve and transmitter stops transmitting signals.
When the internal circuit of any tire pressure warning valve and transmitter is malfunctioning, one of these DTCs is stored.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C2141/41 C2142/42 C2143/43 C2144/44 |
If an "ERROR" signal is received 3 times consecutively, the tire pressure warning valve and transmitter will be judged as defective and a DTC will be stored. This will happen in situations where the inflation pressure is outside the range -100 to 538 kPa (-1.0 to 5.4 kgf/cm2 , -14 to 78 psi), the temperature inside the tire is outside the specified range -40 to 120°C (-40 to 248°F), or an error occurs in the tire pressure warning valve and transmitter or the surrounding area. |
|
HINT:
It is necessary to perform this procedure to identify the malfunctioning tire pressure warning valve and transmitter as it cannot be identified only by the output DTC.