Problem Symptoms Table [08/2013 - ]

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

SFI SYSTEM

Symptom	Suspected Area	Refer To
Engine does not crank (Does not start)	Immobilizer system	Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]
	Battery	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Cranking holding function circuit	Refer to Cranking Holding Function Circuit [08/2013 - ]
	Smart access system with push button start	Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]
	Starter assembly	Refer to INSPECTION [08/2013 - ]
	VC output circuit (ECM 5 V output)	Refer to VC Output Circuit [08/2013 - ]
No initial combustion (Does not start)	ECM power source circuit	Refer to ECM Power Source Circuit [08/2013 - ]
	VC output circuit (ECM 5 V output)	Refer to VC Output Circuit [08/2013 - ]
	Crankshaft position sensor	Refer to INSPECTION [08/2013 - ]
	Fuel pump control circuit	Refer to Fuel Pump Control Circuit [08/2013 - ]
	Ignition system	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Valve timing	Refer to PROCEDURE - Step 4
Engine cranks normally but difficult to start	Fuel pump control circuit	Refer to Fuel Pump Control Circuit [08/2013 - ]
	Fuel pump for high pressure	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Engine coolant temperature sensor	Refer to INSPECTION [08/2013 - ]
	Ignition system	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Fuel injector assembly	Refer to INSPECTION [08/2013 - ]
	Compression	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 10
	Intake system	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1
	Throttle body assembly	Refer to INSPECTION [08/2013 - ]
	Cold start injector circuit	Refer to Cold Start Injector Circuit [08/2013 - ]
	ECM power source circuit	Refer to ECM Power Source Circuit [08/2013 - ]
Incomplete intermittent combustion occurs (Does not start)	Fuel pump control circuit	Refer to Fuel Pump Control Circuit [08/2013 - ]
	Fuel pump for high pressure	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Fuel line	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Ignition system	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Fuel injector assembly	Refer to INSPECTION [08/2013 - ]
	Crankshaft position sensor	Refer to INSPECTION [08/2013 - ]
	Valve timing	Refer to PROCEDURE - Step 4
High engine speed (Poor idle)	Air conditioning signal circuit	Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]
	Throttle body assembly	Refer to INSPECTION [08/2013 - ]
	Throttle body assembly control	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Engine coolant temperature sensor	Refer to INSPECTION [08/2013 - ]
	PCV hose	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	PCV system	Refer to INSPECTION [08/2013 - ]
	ACIS control circuit	Refer to ACIS Control Circuit [08/2013 - ]
Low engine speed (Poor idle)	Fuel pump control circuit	Refer to Fuel Pump Control Circuit [08/2013 - ]
	Throttle body assembly	Refer to INSPECTION [08/2013 - ]
	Throttle body assembly control	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Intake system	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1
	ACIS control circuit	Refer to ACIS Control Circuit [08/2013 - ]
	PCV hose	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	PCV system	Refer to INSPECTION [08/2013 - ]
Engine stalls on deceleration	Idle speed (refer to "Low engine speed")	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 9
Rough idle	Compression (engine mechanical)	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 10
	Air fuel ratio sensor	Refer to INSPECTION [08/2013 - ]
	Heated oxygen sensor	Refer to INSPECTION [08/2013 - ]
	Mass air flow meter	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Ignition system	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Air conditioning signal circuit	Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]
	Fuel line	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Valve timing	Refer to PROCEDURE - Step 4
	Fuel pump for low or high pressure	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1
	Intake system	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1
	ACIS control circuit	Refer to ACIS Control Circuit [08/2013 - ]
	PCV hose	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	PCV system	Refer to INSPECTION [08/2013 - ]
Hunting (Poor idle)	PCV hose	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	PCV system	Refer to INSPECTION [08/2013 - ]
	Mass air flow meter	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Air fuel ratio sensor	Refer to INSPECTION [08/2013 - ]
	ACIS control circuit	Refer to ACIS Control Circuit [08/2013 - ]
Engine stalls during air conditioning operation	Air conditioning signal circuit (compressor circuit)	Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]
	ECM	Refer to REMOVAL [08/2013 - ]
	Cold start injector circuit	Refer to Cold Start Injector Circuit [08/2013 - ]
Hesitation/Poor acceleration (Poor driveability)	Fuel line	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Fuel pump for low or high pressure	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1
	Valve timing	Refer to PROCEDURE - Step 4
	Mass air flow meter	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Throttle body assembly	Refer to INSPECTION [08/2013 - ]
	Knock control sensor	Refer to INSPECTION [08/2013 - ]
	Brake override system	Refer to Brake Override System [08/2013 - ]
Surging (Poor driveability)	Fuel line	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Fuel pump control circuit	Refer to Fuel Pump Control Circuit [08/2013 - ]
	Fuel pump for high pressure	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Ignition system	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Fuel injector assembly	Refer to INSPECTION [08/2013 - ]
Engine stalls soon after starting	Mass air flow meter	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Intake system	Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1
	Fuel line	Refer to ON-VEHICLE INSPECTION [08/2013 - ]
	Cold start injector circuit	Refer to Cold Start Injector Circuit [08/2013 - ]
Unable/difficult to refuel	Fuel system (canister, refueling valve, roll over valve, fuel tank, etc.)	-