LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> GX 460 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System / Washer System (W/O Rain Sensor) (Diagnostics & Circuit Tests) >> WIPER AND WASHER SYSTEM (W/O Rain Sensor) >> Circuit Tests >> Headlight Signal Circuit [08/2013 - ] >> Procedure

Headlight Signal Circuit [08/2013 - ]: Procedure

  1. CHECK HEADLIGHT CLEANER CONTROL RELAY (HDLO VOLTAGE) 
    1. Remove the main body ECU (multiplex network body ECU) with the connector(s) still connected. Refer to REMOVAL [08/2013 - ] .
      GTY466140Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Switch Condition Specified Condition
      G46-16 (HDLO) - Body ground Headlight dimmer switch in head Below 1 V
      G46-16 (HDLO) - Body ground Headlight dimmer switch not in head 11 to 14 V
      TEXT IN ILLUSTRATION

      *a Component with harness connected
      (Main Body ECU [Multiplex Network Body ECU])

    NG → See step   2 

    OK → See step   3 

  2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - HEADLIGHT CLEANER CONTROL RELAY) 
    1. Disconnect the G46 main body ECU (multiplex network body ECU) connector.
    2. Disconnect the A32 headlight cleaner control relay connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      G46-16 (HDLO) - A32-1 (HDLO) Always Below 1 Ω
      G46-16 (HDLO) or A32-1 (HDLO) - Body ground Always 10 kΩ or higher

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   4 

  3. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [08/2013 - ] 
  4. REPLACE HEADLIGHT CLEANER CONTROL RELAY. Refer to  REMOVAL [08/2013 - ] 
scientia non olet · About LEMON Manuals