Fail-Safe Table [09/2013 - ]

If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTC	Component	Fail-safe Operation	Fail-safe Deactivation Condition
P0031, P0032, P0051, P0052, P101D and P103D	Air fuel ratio sensor heater	ECM turns off air fuel ratio sensor heater	Power switch off
P0037, P0038, P0057, P0058, P103D and P105D	Heated oxygen sensor heater	ECM turns off heated oxygen sensor heater	Power switch off
P0087 and P0088	Fuel pump for high pressure	Stop the fuel pump for high pressure Limit the engine speed to 2000 rpm or less	Pass condition detected
P0102 and P0103	Mass air flow meter	ECM calculates ignition timing according to engine speed and throttle valve position	Pass condition detected
P0112 and P0113	Intake air temperature sensor	ECM estimates intake air temperature sensor to be 20°C (68°F)	Pass condition detected
P0115, P0117 and P0118	Engine coolant temperature sensor	ECM estimates engine coolant temperature sensor to be 80°C (176°F)	Pass condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060E, P1607, P2102, P2103, P2111, P2112, P2118, P2119 and P2135	Electronic throttle control system	The ECM cuts off throttle actuator current and the throttle valve returns to 6° throttle position by return spring The ECM stops the engine and the vehicle can be driven using solely the hybrid system.*1	Pass condition detected and then power switch turned off
P0192 and P0193	Fuel pressure sensor	Stop the fuel pump for high pressure Limit the engine speed to 2000 rpm or less	Pass condition detected and then power switch turned off
P0201, P0202, P0203, P0204, P0205 and P0206	Injector driver (EDU)	Stop fuel injection for an abnormal cylinder and related other cylinders Limit the engine speed to 3000 rpm or less	Pass condition detected and then power switch turned off
P0327, P0328, P0332 and P0333	Knock sensor	The ECM sets ignition timing to maximum retard	Power switch off
P0351, P0352, P0353, P0354, P0355 and P0356	Ignition coil assembly	The ECM cuts fuel	Pass condition detected
P1235	Fuel pump (for high pressure side).	Stop the fuel pump for high pressure Limit the engine speed to 2000 rpm or less	Pass condition detected
P1276, P1277, P1278, P1279, P127A, P127B	Fuel injector assembly (for port injection)	Limit the engine speed to 2000 rpm or less Fuel cut of malfunction cylinder	Pass condition detected and then power switch turned off
P2237, P2238, P2239, P2240, P2241, P2242, P2252, P2253, P2255, P2256	A/F Sensor	Air-fuel ratio feedback control is stopped	Pass condition detected and then power switch turned off

NOTE:

*1: The vehicle can be driven slowly when the accelerator pedal is depressed slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.
*2: Misfire related fail-safe operations occur when catalyst overheat malfunctions occur.