LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2014 >> ES 300h >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio / Video System (W/ Multi-Display) (Diagnostic Codes & Symptom Tests) >> Audio And Visual System (W/ Multi-Display Without Parking Assist Monitor System) >> Circuit Tests >> Radio Receiver Power Source Circuit [08/2013 - ] >> Procedure

Radio Receiver Power Source Circuit [08/2013 - ]: Procedure

  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE) 
    1. Disconnect the H89 and H90 radio receiver assembly connectors.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      H90-20 (GND1) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      H90-1 (+B1) - H90-20 (GND1) Power switch off 11 to 14 V
      H90-11 (ACC1) - H90-20 (GND1) Power switch on (ACC) 11 to 14 V
      H89-1 (IG) - H90-20 (GND1) Power switch on (IG) 11 to 14 V

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   2 

  2. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [08/2013 - ] 
scientia non olet · About LEMON Manuals