Common Specs & Procedures
RX450h COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SERVICE DATA [03/2012 - ] | ||
| Torque | TORQUE SPECIFICATIONS [03/2012 - ] | ||
| Axle Nut/Hub Nut | |||
| Front | 294 N.m (2, 998 kgf.cm 217 ft.lbf) | ||
| Rear | 294 N.m (2, 998 kgf.cm 217 ft.lbf) | ||
| Battery | SERVICE DATA [03/2012 - ] | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING [03/2012 - ] | ||
| Front | SERVICE DATA [03/2012 - ] | ||
| Torque | TORQUE SPECIFICATIONS [03/2012 - ] | ||
| Rear | SERVICE DATA [03/2012 - ] | ||
| Torque | TORQUE SPECIFICATIONS [03/2012 - ] | ||
| Charging | |||
| Generator | SERVICE DATA [03/2012 - ] | ||
| Torque | TORQUE SPECIFICATIONS [03/2012 - ] | ||
| Drive Belts | |||
| Adjustment | Uses belt tensioner | ||
| Belt Routing | INSTALLATION [03/2012 - ] | ||
| Engine Cooling | |||
| General Service Specifications | SERVICE DATA [03/2012 - ] | ||
| Radiator Cap Pressure | New cap: 94 to 122 kPa (1.0 to 1.2 kgf/cm2
, 13.5 to 17 psi) Used cap: 79 kPa (0.8 kgf/cm2 , 11.4 psi) |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | SERVICE DATA [03/2012 - ] | ||
| Oil Pressure | at idle speed: 40 kPa (0.4 kgf/cm2
, 5.8 psi) or more at 2, 500 RPM: 200 kPa (2.0 kgf/cm2 , 29 psi) or more |
||
| Overhaul | SERVICE DATA [03/2012 - ] | ||
| Torque | TORQUE SPECIFICATIONS [03/2012 - ] | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 83 N.m (846 kgf.cm, 61 ft.lbs) | ||
| Fuel System | |||
| Pressure Specification | 380 to 420 kPa (3.8 to 4.2 kgf/cm2 , 55 to 61 psi) | ||
| Fuel pressure remains for 5 minutes after engine has stopped | 147 kPa (1.5 kgf/cm2 , 21 psi) or more | ||
| Fuel Pressure Test Procedure | ON-VEHICLE INSPECTION [03/2012 - ] | ||
| Fuel Filter Location | FUEL PUMP | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plug | |||
| Type | FK20HR11 | ||
| Gap | Electrode gap for new spark plug 1.0 - 1.1 mm (0.0394 - 0.0433 in.) Maximum electrode gap for used spark plug 1.4 mm (0.0551 in.) |
||
| Torque | 18 N.m (184 kgf.cm, 13 ft.lbf) | ||
| Starting | |||
| Starter | SERVICE DATA [03/2012 - ] | ||
| Torque | N/A | ||
| Wheel Alignment | |||
| Adjustment Specifications | SERVICE DATA [03/2012 - ] | ||
| Torque | TORQUE SPECIFICATIONS [03/2012 - ] | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 103 N.m (1, 050 kgf.cm 76 ft.lbf) | ||