How To Proceed With Troubleshooting [01/2012 - ]

HINT: 

• Use the following procedures to troubleshoot the front power seat control system.

• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

3. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.
      RESULT
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

      B → Go to CAN COMMUNICATION SYSTEM. Refer to  PRECAUTION [01/2012 - ] 

      A: Go to next step 

4. PROBLEM SYMPTOMS TABLE 
   1. Refer to the Problem Symptoms Table. Refer to PROBLEM SYMPTOMS TABLE [01/2012 - ] .
      RESULT
      
      

      Result	Proceed to
      Fault is not listed in problem symptoms table	A
      Fault is listed in problem symptoms table	B

      B → Go to step   6 

      A: Go to next step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Data List / Active Test. Refer to DATA LIST / ACTIVE TEST [01/2012 - ] 
   2. Terminals of ECU. Refer to TERMINALS OF ECU [01/2012 - ] 
   3. Operation Check. Refer to OPERATION CHECK [01/2012 - ] 

      NEXT: Go to next step 

6. REPAIR OR REPLACE 

   NEXT: Go to next step 

7. CONFIRMATION TEST 

   NEXT → END