Millimeter Wave Radar Sensor Power Source Circuit: Procedure
- CHECK HARNESS AND CONNECTOR (FRONT MILLIMETER WAVE RADAR SENSOR - DRIVING SUPPORT ECU)
- Disconnect the B9 sensor connector.
- Disconnect the A33 ECU connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition B9-2 (SGND) - A33-26 (SGND) Always Below 1 Ω B9-5 (IGB) - A33-36 (IGB) Always Below 1 Ω B9-2 (SGND) - Body ground Always 10 kΩ or higher B9-5 (IGB) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to next step
- CHECK DRIVING SUPPORT ECU (IGB VOLTAGE SIGNAL)
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Switch Condition Specified Condition B9-5 (IGB) - B9-2 (SGND) Engine switch on (IG) 11 to 14 V
NG → See step 4
OK → See step 3
- Measure the voltage according to the value(s) in the table below.
- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [09/2012 - ]
- REPLACE DRIVING SUPPORT ECU. Refer to REMOVAL [09/2012 - ]