DTC U1331: Software Incompatibility with Body Control Module "B": Procedure

1. Check the main body ECU (driver side junction block) part number.
   1. Check if the part number of the main body ECU (driver side junction block) installed on the vehicle is correct.

      OK

      The part number is correct.

NG → REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK) 

OK: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [09/2012 - ] .
2. Recheck for DTCs and check if the same DTC is output again.
   RESULT
   
   

   Result	Proceed to
   No DTC is output	A
   DTC is output from the blind spot monitor sensor LH (Master)	B
   DTC is output from the blind spot monitor sensor RH (Slave)	C

B → See step   5 

C → See step   4 

A → See step   3