Display does not Dim when Light Control Switch is Turned ON: Procedure

1. Check the symptoms that occur by viewing the display.

   Result

   Result	Proceed to
   There is a delay until the display dims after the navigation system is activated with the light control switch in the tail or head position.	A
   The display dims for a moment and then becomes bright after the navigation system is activated with the light control switch in the tail or head position.	B
   When the light control switch is set to the tail or head position, the display dims but does not switch to the night screen.	B
   When the light control switch is set to the tail or head position, the display neither dims nor switches to the night screen.	C

   HINT: 

   • When the navigation system is activated with the light control switch in the tail or head position, before AVC-LAN communication is established, the multi-display assembly dims the display according to the illumination signal received via a direct line.
   • After AVC-LAN communication is established, the multi-display assembly dims the display according to a dimmer signal sent via AVC-LAN communication.
   • The multi-media module receiver assembly switches between the daytime screen and night screen on the multi-display assembly according to the illumination signal input.

B → See step   3 

C → See step   9 

A: Go to next step 

1. Disconnect the J126 multi-display assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J126-13 (GND1) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   J126-2 (ILL) - J126-13 (GND1)	Light control switch in tail or head position	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   8 

1. Display the "Display" screen.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Turn the light control switch to the tail or head position.
3. Check if "Day Mode" setting on the display adjustment screen is on.

   Result

   Result	Proceed to
   "Day Mode" setting is on	A
   "Day Mode" setting is off	B

   TEXT IN ILLUSTRATION
   
   

   *a

   Example

B → See step   4 

A → TURN "Day Mode" SETTING OFF 

1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check. Refer to OPERATION CHECK [08/2012 - ] .

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Check that the display changes between ON and OFF according to the light control switch operation.

   OK

   Light Control Switch	Display
   Tail or head	ON
   Off	OFF

   HINT: 

   The display is updated once per second. It is normal for the display to lag behind the actual switch operation.

NG → See step   5 

OK → See step   6 

1. Disconnect the J125 multi-media module receiver assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J125-12 (GND1) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   J125-14 (ILL+) - J125-12 (GND1)	Light control switch in tail or head position	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   7