Antenna Circuit: Procedure

1. Remove the outside handle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disconnect the antenna and door oscillator connectors.

   Standard resistance

   Tester Connection (Symbols)	Condition	Specified Condition
   o1-2 (ANT2) - o2-8 (ANT2) (*1)	Always	Below 1 Ω
   o1-6 (SGT) - o2-2 (SGT) (*1)	Always	Below 1 Ω
   o1-5 (ANT1) - o2-3 (ANT1) (*1)	Always	Below 1 Ω
   o1-2 (ANT2) - Body ground (*1)	Always	10 kΩor higher
   o1-6 (SGT) - Body ground (*1)	Always	10 kΩor higher
   o1-5 (ANT1) - Body ground (*1)	Always	10 kΩor higher
   n1-2 (ANT2) - n2-8 (ANT2) (*2)	Always	Below 1 Ω
   n1-6 (SGT) - n2-2 (SGT) (*2)	Always	Below 1 Ω
   n1-5 (ANT1) - n2-3 (ANT1) (*2)	Always	Below 1 Ω
   n1-2 (ANT2) - Body ground (*2)	Always	10 kΩor higher
   n1-6 (SGT) - Body ground (*2)	Always	10 kΩor higher
   n1-5 (ANT1) - Body ground (*2)	Always	10 kΩor higher

   *1: Driver side

   *2: Passenger side

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Replace the door outside handle.
2. Check that the entry LOCK/UNLOCK function operates normally.

   OK

   Entry LOCK/UNLOCK function operates normally.

NG → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

OK → END (DOOR OUTSIDE HANDLE IS DEFECTIVE)