LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2013 >> IS 250 Base, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System (Service Information) >> Steering Angle Sensor >> Installation [08/2012 - ] >> Installation [08/2012 - ]

Installation [08/2012 - ]

  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the locating pins, engage the 6 claws and install the steering angle sensor to the spiral cable sub-assembly.
      Fig 1: Identifying Steering Angle Sensor & Claws
      GTY128360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR  . Refer to INSTALLATION [08/2012 - ] - Step 2
  3. INSTALL STEERING COLUMN COVER  . Refer to INSTALLATION [08/2012 - ] - Step 7
  4. INSTALL STEERING WHEEL ASSEMBLY  . Refer to INSTALLATION [08/2012 - ] - Step 9
  5. INSTALL STEERING PAD  . Refer to INSTALLATION [08/2012 - ] - Step 1
  6. INSTALL NO. 3 LOWER STEERING WHEEL COVER  . Refer to INSTALLATION [08/2012 - ] - Step 2
  7. INSTALL NO. 2 LOWER STEERING WHEEL COVER  . Refer to INSTALLATION [08/2012 - ] - Step 3
  8. INSPECT STEERING WHEEL CENTER POINT 
    1. Inspect the steering wheel center point.
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2012 - ] .
  10. INSPECT STEERING PAD  . Refer to INSTALLATION [08/2012 - ] - Step 5
  11. INSPECT SRS WARNING LIGHT 

    HINT: 

    Refer to DIAGNOSIS SYSTEM [08/2012 - ]

scientia non olet · About LEMON Manuals