DTC P0575: Cruise Control Input Circuit: Procedure

CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .
2. Perform the following to make sure the DTC detection conditions are met.
  HINT:
  
  If the detection conditions are not met, the system cannot detect the malfunction.
  1. Drive the vehicle at a speed of 50 km/h (30 mph) or more.
  2. Turn the cruise control switch on.
  3. Push the cruise control switch to -SET to activate cruise control.
3. Check for DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .
  OK
  
  DTC P0575 is not output.
NG → See step 3

OK → See step 2
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2012 - ]
REPLACE ECM. Refer to REMOVAL [06/2012 - ]