DTC P0575: Cruise Control Input Circuit: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Clear the DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .
4. Perform the following to make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the malfunction cannot be detected.

   1. Drive the vehicle at a speed of 50 km/h (31 mph) or more.
   2. Turn the dynamic radar cruise control system on using the cruise control switch (ON-OFF button).
   3. Push the cruise control switch to -SET to activate the dynamic radar cruise control system.
5. Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
6. Check for DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC P0575 is output	B

7. Turn the engine switch off.

B → See step   2 

A → See step   3