Multi-media Interface ECU Power Source Circuit: Procedure

1. Disconnect the multi-media interface ECU assembly connector.
2. Measure the voltage according to the value(s) in the table below.
   Fig 1: Identifying Multi-Media Interface ECU Assembly Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   H69-12 (+B) - H69-7 (GND)	Power switch off	11 to 14 V
   H69-11 (ACC) - H69-7 (GND)	Power switch on (ACC)	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Multi-media Interface ECU Assembly)

NG → See step   2 

OK → See step   3 

1. Disconnect the radio receiver assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H69-11 (ACC) - H53-11 (ACC)	Always	Below 1 Ω
   H69-12 (+B) - H53-12 (+B)	Always	Below 1 Ω
   H69-7 (GND) - H53-7 (GND)	Always	Below 1 Ω
   H69-11 (ACC) - Body ground	Always	10 kΩ or higher
   H69-12 (+B) - Body ground	Always	10 kΩ or higher
   H69-7 (GND) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   3