Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier: Procedure
- CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY- STEREO COMPONENT AMPLIFIER ASSEMBLY)
- Disconnect the radio receiver assembly and stereo component amplifier assembly connectors.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition J107-9 (L+) - P30-3 (L+) Always Below 1 Ω J107-19 (L-) - P30-2 (L-) Always Below 1 Ω J107-8 (R+) - P30-5 (R+) Always Below 1 Ω J107-18 (R-) - P30-4 (R-) Always Below 1 Ω J107-9 (L+) - Body ground Always 10 kΩ or higher J107-19 (L-) - Body ground Always 10 kΩ or higher J107-8 (R+) - Body ground Always 10 kΩ or higher J107-18 (R-) - Body ground Always 10 kΩ or higher J107-10 (SLD) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE