Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier: Procedure
- CHECK HARNESS AND CONNECTOR
- Disconnect the radio receiver assembly and stereo component amplifier assembly connectors.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition J108-11 (IVO+) - P30-15 (II1+) Always Below 1 Ω J108-12 (IVO-) - P30-14 (II1-) Always Below 1 Ω J108-11 (IVO+) - Body ground Always 10 kΩ or higher J108-12 (IVO-) - Body ground Always 10 kΩ or higher J108-13 (SLD1) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE