Sound Signal Circuit between Multi-display and Multi-media Interface ECU: Procedure
- CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY - MULTI-MEDIA INTERFACE ECU)
- Disconnect the display and navigation module display connector and multi-media interface ECU connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition J105-1 (AGND) - J112-1 (USD1) Always Below 1 Ω J105-3 (VAR+) - J112-2 (URO+) Always Below 1 Ω J105-4 (VAL+) - J112-3 (ULO+) Always Below 1 Ω J105-7 (VA-) - J112-4 (UGD1) Always Below 1 Ω J105-1 (AGND) - Body ground Always 10 kΩ or higher J105-3 (VAR+) - Body ground Always 10 kΩ or higher J105-4 (VAL+) - Body ground Always 10 kΩ or higher J105-7 (VA-) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE