LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2012 >> IS 250 Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) >> Navigation Ecu >> Installation >> Installation

Navigation Ecu: Installation: Installation

  1. INSTALL NAVIGATION ECU 
    1. Install the navigation ECU with the 4 screws.
      Fig 1: Identifying Navigation ECU & Screws
      GTY278564Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect each connector to install the harness.
    3. Engage the clamp.
  2. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY ASSEMBLY  See step  4
  3. INSTALL NO. 2 RADIO BRACKET  . Refer to INSTALLATION - Step 6
  4. INSTALL NO. 1 RADIO BRACKET  . Refer to INSTALLATION - Step 7
  5. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY  . Refer to INSTALLATION - Step 8
  6. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL  . Refer to INSTALLATION - Step 41
  7. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY  . Refer to INSTALLATION - Step 42
  8. INSTALL FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray)  . Refer to INSTALLATION - Step 46
  9. INSTALL INSTRUMENT PANEL BOX ASSEMBLY (w/o Ashtray)  . Refer to INSTALLATION - Step 47
  10. INSTALL FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  . Refer to INSTALLATION - Step 48
  11. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  . Refer to INSTALLATION - Step 49
  12. INSTALL CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)  . Refer to INSTALLATION - Step 50
  13. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission)  . Refer to INSTALLATION - Step 51
  14. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission)  . Refer to INSTALLATION - Step 52
  15. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) 
  16. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) 
  17. INSERT MAP DISC 
    1. Remove the clock assembly
      Fig 2: View Of Removing Clock Assembly
      GTY278560Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Turn the engine switch on (ACC).
    3. Insert the map disc.
    4. Check that the wire harness is in the position shown in the illustration.
      Fig 3: Identifying Clock & Wire Harness
      GTY278757Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Clock
      *2 Wire Harness
    5. Engage the 2 craws and install the clock assembly.
      Fig 4: Identifying Clock Assembly Claws
      GTY278568Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  18. ADJUST CLOCK 
scientia non olet · About LEMON Manuals