LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2011 >> LS 600hL >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System And Washer System (Diagnostics & Circuit Tests) >> Wiper And Washer System >> Circuit Tests >> ECU Power Source Circuit >> Procedure

ECU Power Source Circuit: Procedure

  1. INSPECT FUSE (WIP) 
    1. Remove the WIP fuse from the engine room No. 2 relay block.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance

      Tester Connection Condition Specified Condition
      WIP fuse Always Below 1 Ω

    NG → REPLACE FUSE 

    OK: Go to next step 

  2. CHECK HARNESS AND CONNECTOR (FRONT CONTROLLER - BATTERY) 
    1. Disconnect the A51 front controller connector.
      Fig 1: Identifying Front Controller Connector Terminals
      GTY153017Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage

      Tester Connection Switch Condition Specified Condition
      A51-2 (WIG) - Body ground Power switch ON (IG) 11 to 14 V
      A51-2 (WIG) - Body ground Power switch OFF Below 1 V

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  3. CHECK HARNESS AND CONNECTOR (FRONT CONTROLLER - BODY GROUND) 
    1. Disconnect the A50 ECU connector.
      Fig 2: Identifying Front Controller Connector Terminals
      GTY152798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance

      Tester Connection Condition Specified Condition
      A50-2 - Body ground Always Below 1 Ω

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → REPLACE FRONT CONTROLLER 

scientia non olet · About LEMON Manuals