LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2011 >> IS 350C >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel System (2GR-FSE) (Service Information) >> Injector Driver >> Installation >> Installation

Injector Driver: Installation: Installation

  1. INSTALL INJECTOR DRIVER 
    1. Install the injector driver with the bolt and 2 nuts.
      Fig 1: Location of Injector Driver Bolt And Nuts
      GTY124269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:
      • Be careful not to drop or strike the injector driver.
      • The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.
    2. Connect the 4 connectors to the injector driver. Move the lock levers in the direction indicated by the arrow to lock the 3 connectors.
      Fig 2: Identifying Injector Driver & 4 Connectors
      GTY274449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 ENGINE COVER  . Refer to INSTALLATION - Step 29
  3. INSTALL NO. 1 INLET AIR CLEANER  . Refer to INSTALLATION - Step 45
  4. INSTALL COOL AIR INTAKE DUCT SEAL  . Refer to INSTALLATION - Step 81
scientia non olet · About LEMON Manuals