4WD Control Ecu: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE FRONT DOOR SCUFF PLATE RH (w/o Illumination)
HINT:

Use the same procedures for the RH side and the LH side. Refer to REMOVAL - Step 27 .
REMOVE FRONT DOOR SCUFF PLATE RH (w/ Illumination)
HINT:

Use the same procedures for the RH side and the LH side. Refer to REMOVAL - Step 28 .
REMOVE FRONT DOOR OPENING TRIM COVER RH . Refer to REMOVAL - Step 38
REMOVE SIDE INSTRUMENT PANEL RH . Refer to REMOVAL - Step 39
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to REMOVAL - Step 40
REMOVE 4WD CONTROL ECU
1. Turn back the front floor carpet assembly.
2. Disengage the 2 clips and separate the junction connector.
  
  Fig 1: Connecting Junction Connector With 2 Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the bolt and nut.
  
  Fig 2: Identifying 4WD Control ECU With Bolt & Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the clamp and connector, and remove the 4WD control ECU.
  
  Fig 3: Identifying Connector & Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002