LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2011 >> HS 250h >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Navigation System (Diagnostic Codes & Circuit Tests) >> Navigation System >> Circuit Tests >> Voice Recognition Difficulty >> Procedure

Voice Recognition Difficulty: Procedure

  1. CHECK CONDITION 
    1. Refer to the owner's manual and follow its instructions to check that the voice recognition level of the system is not too low for a particular voice.

      Result

      Result Proceed to
      System voice recognition level is low with any voice. A
      System voice recognition level is low only for a particular voice. B

      HINT: 

      System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.

    B → END 

    A: Go to next step 

  2. CHECK MICROPHONE (OPERATION CHECK) 
    1. Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check. Refer to OPERATION CHECK .
      Fig 1: Identifying Microphone & Voice Recognition Check Display Screen
      GTY257510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
    3. Select the recording switch and perform voice recording.
      • Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
      • Voice can be recorded up to 5 seconds.
    4. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

      OK

      All check results are normal.

      TEXT IN ILLUSTRATION

      *1 Microphone Input Level Meter
      *2 Recording Switch
      *3 Stop Switch
      *4 Play Switch
      *5 Recording Indicator

    NG → See step   4 

    OK: Go to next step 

  3. REPLACE HARD DISK DRIVE 
    1. Replace the hard disk drive. Refer to REMOVAL .
    2. Check that voice recognition is normal.

      OK

      Voice can be recognized normally.

    NG → See step   5 

    OK → END 

  4. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE 
  5. REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY. Refer to  REMOVAL