LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2011 >> HS 250h >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Audio / Video System (W/O Navigation System) (Diagnostic Codes & Circuit Tests) >> AUDIO AND VISUAL SYSTEM (w/o Navigation System) >> Circuit Tests >> Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter >> Procedure

Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter: Procedure

  1. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) 
    1. Check the output waveform.
      Fig 1: Identifying F4 Combination Meter Assembly Connector & Output Waveform
      GTY259884Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the combination meter assembly with the connector still connected.
      2. Connect an oscilloscope to terminal F4-40 (+S) and body ground.
      3. Turn the power switch on (IG).
      4. Turn a wheel slowly.
      5. Check the signal waveform according to the condition(s) in the table below.
        Item Condition
        Tool setting 5 V/DIV., 20 ms./DIV.
        Vehicle condition Wheel being rotated

        OK

        The waveform is similar to that shown in the illustration.

        HINT: 

        When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

        TEXT IN ILLUSTRATION

        *1 Component with harness connected
        (Combination Meter Assembly)

    NG → See step   6 

    OK: Go to next step 

  2. CHECK HARNESS AND CONNECTOR 
    1. Disconnect the stereo component amplifier assembly and combination meter assembly connectors.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      F69-11 (SPD) - F4-40 (+S) Always Below 1 Ω

    NG → See step   3 

    OK → See step   5 

  3. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - JUNCTION CONNECTOR) 
    1. Disconnect the stereo component amplifier assembly connector.
    2. Disconnect the junction connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      F69-11 (SPD) - F96-34 Always Below 1 Ω

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  4. CHECK HARNESS AND CONNECTOR (JUNCTION CONNECTOR) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      F96-34 - F96-53 Always Below 1 Ω

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (JUNCTION CONNECTOR) 

    OK → See step   5 

  5. REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY. Refer to  REMOVAL 
  6. GO TO METER / GAUGE SYSTEM. Refer to  Speed Signal Circuit