DTC P2121: Throttle/Pedal Position Sensor/Switch "D" Circuit Range/Performance: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain/Engine/Trouble Codes.
5. Read the DTCs.

   Result

   Display (DTC Output)	Proceed to
   P2121	A
   No output	B

   HINT: 

   If any DTCs other than P2121 are output, trouble shoot those DTCs first.

B → See step   6 

A: Go to next step 

1. Connect the Techstream to the DLC3.
   Fig 1: Checking Brake Pedal Depressed & Released

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the engine switch on (IG) and turn the Techstream on.
3. Enter the following menus: Powertrain/Engine/Data List/Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
4. Read the values displayed on the Techstream.

   Standard voltage

   Accelerator Pedal Operation	Accel Sensor Out No. 1	Accel Sensor Out No. 2	Difference between Accel Sensor Out No. 1 and Accel Sensor Out No. 2
   Released	0.5 to 1.1 V	1.2 to 2.0 V	More than 0.02 V
   Depressed	2.6 to 4.5 V	3.4 to 4.7 V

NG → See step   3 

OK → See step   7 

1. Replace the accelerator pedal rod assembly. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG) and turn the Techstream on.
3. Clear the DTCs. Refer to DTC CHECK/CLEAR .
4. Start the engine.
5. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
6. Enter the following menus: Powertrain/Engine/Trouble Codes.
7. Read the DTCs.

   Result

   Display (DTC Output)	Proceed to
   P2121	A
   No output	B

B → END 

A → See step   5