LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2011 >> ES 350 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Smart Access System (Keyless Entry) (Diagnostic Codes & Circuit Tests) >> Smart Access System With Push-Button Start >> Circuit Tests >> Certification ECU Power Source Circuit >> Procedure

Certification ECU Power Source Circuit: Procedure

  1. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) 
    1. Disconnect the E13 certification ECU connector.
      Fig 1: Checking Harness And Connector (Power Source Circuit)
      GTY118490Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage

      Tester Connection (Symbols) Condition Specified Condition
      E13-1 (+B1) - Body ground Always 10 to 14 V
      E13-18 (IG) - Body ground Engine switch OFF Below 1 V
      Engine switch ON (IG) 10 to 14 V
      E13-19 (ACC) - Body ground Engine switch OFF Below 1 V
      Engine switch ON (ACC) 10 to 14 V
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance

      Tester Connection (Symbols) Condition Specified Condition
      E13-17 (E) - Body ground Always Below 1 Ω

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

scientia non olet · About LEMON Manuals