LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> SC 430 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging (Service Information) >> Generator >> Removal >> Removal

Charging (Service Information): Generator: Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE NO. 1 AIR CLEANER INLET  . Refer to REMOVAL - Step 1
  3. REMOVE V-BANK COVER  . Refer to REMOVAL - Step 4
  4. REMOVE ENGINE UNDER COVER 
  5. REMOVE FAN & GENERATOR V BELT  . Refer to REMOVAL - Step 2
  6. REMOVE VANE PUMP PULLEY 
      Fig 1: Identifying Vane Pump Pulley With Nut
      GTY126650Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Using SST, remove the nut and vane pump pulley.
      • SST: 09960-10010 
  7. REMOVE GENERATOR ASSEMBLY 
    1. Disconnect the generator connector.
    2. Remove the rubber cap and nut, and disconnect the generator wire.
    3. Remove the bolt and disconnect the engine wire bracket.
      4. Fig 2: Identifying Generator Nuts And Bolt
      GTY126712Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the stud bolt of the nut is loose, replace the stud bolt.

    4. Remove the 2 nuts, bolt and generator.
scientia non olet · About LEMON Manuals