Transmission Wire: Installation: Installation

INSTALL TRANSMISSION WIRE
1. Coat the O-ring of the transmission wire connector with ATF.
2. Install the 2 transmission wires with the 2 bolts.
  
  Fig 1: Identifying Transmission Wires And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
3. Connect the 2 transmission wire connectors.
  
  Fig 2: Identifying Transmission Wire Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Push up the lever until the claw of the transmission wire connector makes a connection sound.
CONNECT TRANSMISSION WIRE

Fig 3: Identifying ATF Temperature Sensors, Connectors, Clamps And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Connect the 9 connectors to the solenoid valves.
2. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
  for bolt A
  
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  for bolt B
  
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
  
  HINT:
  
  Each bolt length is indicated below.
  
  12 mm (0.472 in.) for bolt A
  
  36 mm (1.41 in.) for bolt B
INSTALL VALVE BODY OIL STRAINER ASSEMBLY

Fig 4: Identifying Oil Strainer And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Coat a new O-ring with ATF and install it to the oil strainer.
2. Install the oil strainer with the 4 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

Fig 5: Identifying Transmission Oil Cleaner Magnets
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the 4 transmission oil cleaner magnets to the oil pan.
2. Install a new gasket and the oil pan with the 12 bolts.
  
  Fig 6: Identifying Oil Pan Assembly And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 7.4 N*m (75 kgf*cm, 65 in.*lbf)
  NOTE:
  Fig 7: Identifying Correct And Incorrect Seal Surface Area
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Make sure that there is no oil or foreign matter on the gasket seal surface and oil pan contact surface.
  - Install the gasket so that there is no slack in the gasket, and make sure the entire circumference of the seal surface is level.
  - Make sure that the 9 gasket drop prevention protrusions are set on the oil pan.
  - When tightening the bolts of the oil pan, make sure that the gasket is not pinched between the gasket tightening area sleeve and the transmission seal surface.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD AUTOMATIC TRANSMISSION FLUID
1. Add automatic transmission fluid. Refer to ADJUSTMENT .
INSTALL OIL PAN PROTECTOR ASSEMBLY See step 36
INSTALL NO. 2 ENGINE UNDER COVER See step 38