Oil Pressure Sensor: Installation: Installation

INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY
1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.
  
  Fig 1: Applying Adhesive To Threads Of Oil Pressure Sender Gauge
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Adhesive
  
  Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
  
  NOTE:
  
  Fig 2: Identifying Oil Hole
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Do not allow adhesive to contact the oil hole.
2. Install the oil pressure sender gauge.
  
  Fig 3: Identifying Oil Pressure Sender Gauge
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  NOTE:
  Do not start the engine within 1 hour after installation.
3. Connect the sender gauge connector.
  
  Fig 4: Identifying Sender Gauge Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADD ENGINE OIL See step 6
INSPECT FOR OIL LEAK See step 7
INSPECT ENGINE OIL LEVEL . Refer to ON-VEHICLE INSPECTION - Step 2
INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 19
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH . Refer to INSTALLATION - Step 17
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH . Refer to INSTALLATION - Step 18