DTC B2313: Glass Position Initialization Incomplete: Procedure

WARNING: This page is about a different car, the 2010 Lexus GS 450h. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM INITIALIZATION (APPLICABLE LOCATION)
1. Turn the power switch on (IG) and initialize the power window regulator motor. Refer to INITIALIZATION .
NEXT: Go to next step

CHECK DTC OUTPUT

Turn the power switch off.
Wait for at least 10 seconds, and then turn the power switch on (IG).

Check for DTCs.

Result

Result	Proceed to
DTC is not output	A
DTC output from front LH motor	B
DTC output from front RH motor	C
DTC output from rear LH motor	D
DTC output from rear RH motor	E

E → See step 6

D → See step 5

C → See step 3

B → See step 4

A → END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH. Refer to REMOVAL - Step 20
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH. Refer to REMOVAL - Step 20
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH. Refer to REMOVAL - Step 21
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH. Refer to REMOVAL - Step 21