LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> LS 460 AWD >> Repair and Diagnosis >> Electrical >> Body Electrical >> Battery Current Sensor (Service Information) >> Battery Current Sensor >> Removal >> Removal

Battery Current Sensor: Removal: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER RH  . Refer to REMOVAL - Step 1
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    NOTE:

    After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

  3. REMOVE ENGINE ROOM SIDE COVER RH  . Refer to REMOVAL - Step 7
  4. REMOVE FRONT FENDER PROTECTOR UPPER RH  . Refer to REMOVAL - Step 8
  5. REMOVE BATTERY CURRENT SENSOR 
    1. Disconnect the connector from the battery current sensor assembly.
    2. Remove the bolt, ground terminal and battery current sensor assembly.
      Fig 1: Identifying Battery Ground Terminal Bolt
      GTY288276Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the battery current sensor assembly from the ground terminal.
scientia non olet · About LEMON Manuals