Stereo Component Amplifier Power Source Circuit: Procedure

INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY

Disconnect the stereo component amplifier assembly connectors.

Fig 1: Identifying P30 And P27 Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*1	Front view of wire harness connector (to Stereo Component Amplifier Assembly)
*2	Front view of wire harness connector (to Stereo Component Amplifier Assembly)

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
P27-2 (GND) - Body ground	Always	Below 1 Ω
P27-6 (GND2) - Body ground	Always	Below 1 Ω

Measure the voltage according to the value(s) in the table below.

Standard Voltage

Tester Connection	Condition	Specified Condition
P27-3 (+B2) - P27-2 (GND)	Always	11 to 14 V
P30-12 (ACC) - P27-2 (GND)	Engine switch on (ACC)	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK → See step 2

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE