LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> IS 250 AWD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Case (Service Information) >> Transfer Valve Body Assembly >> Installation >> Installation

Transfer Valve Body Assembly: Installation: Installation

  1. INSTALL TRANSFER CONTROL SOLENOID  See step  4
  2. INSTALL TRANSFER VALVE BODY ASSEMBLY 
    1. Connect the transfer wire connector to the transfer control solenoid.
      Fig 1: Identifying Transfer Valve Body Assembly
      GTY100519Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the transfer upper valve body with the 4 bolts.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

  3. INSTALL TRANSFER OIL PAN  See step  2
  4. INSTALL TRANSFER DYNAMIC DAMPER  See step  3
  5. INSTALL ENGINE REAR MOUNTING MEMBER  See step  4
  6. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR  . Refer to INSTALLATION - Step 3
  7. INSTALL FRONT EXHAUST PIPE ASSEMBLY  . Refer to INSTALLATION - Step 4
  8. INSTALL HEATED OXYGEN SENSOR  . Refer to INSTALLATION - Step 6
  9. INSTALL FRONT CENTER FLOOR BRACE  . Refer to INSTALLATION - Step 7
  10. INSTALL REAR NO. 1 FLOOR PANEL BRACE  . Refer to INSTALLATION - Step 8
  11. ADD AUTOMATIC TRANSMISSION FLUID  . Refer to INSTALLATION - Step 28
  12. CHECK FOR EXHAUST GAS LEAKS 
scientia non olet · About LEMON Manuals