Typical Enabling Conditions
ALL
| Monitor runs whenever following DTCs are not present | None |
MANUAL TRANSMISSION MODELS (CASE 1)
| Engine switch | On (IG) |
| Time after engine switch off to on (IG) | 3 seconds or more |
| Battery voltage | 8 V or more |
| Starter | OFF |
| ECT | 70°C or more |
| Fuel cut at high engine speed | Not operating |
| Engine speed | 2000 to 5000 rpm |
| Engine load | 30.15% |
| ECT sensor circuit fail (P0115, P0117 and P0118) | Not detected |
| MAF sensor circuit fail (P0101, P0102 and P0103) | Not detected |
MANUAL TRANSMISSION MODELS (CASE 2)
| Engine switch | On (IG) |
| Time after engine switch off to on (IG) | 3 seconds or more |
| Battery voltage | 8 V or more |
| Starter | OFF |
AUTOMATIC TRANSMISSION MODELS
| Engine switch | On (IG) |
| Time after engine switch off to on (IG) | 3 seconds or more |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Either of the following conditions is met: | Condition A or B |
| A, All of the following conditions are met: | Conditions (a) , (b) and (c) |
| (a) ECT | 20°C or more |
| (b) ECT sensor circuit fail (P0115, P0117 and P0118) | Not detected |
| (c) Time after park/neutral position switch on to off | 10 seconds or more |
| B, Both of the following conditions are met: | Conditions (d) and (e) |
| (d) Either of the following conditions is met: | Condition 1 or 2 |
| 1, ECT | Less than 20°C |
| 2, ECT sensor circuit fail (P0115, P0117, P0118 and P0125) | Not detected |
| (e) Time after park/neutral position switch on to off | 30 seconds or more |