LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> GS 460 >> Repair and Diagnosis >> External Pages >> Different car >> Section 282 (Engine Control System (Service Information)) >> Crankshaft Position Sensor >> Installation >> Installation

Crankshaft Position Sensor: Installation: Installation

WARNING: This page is about a different car, the 2010 Lexus GS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a coat of engine oil to the O-ring of the sensor.
    2. Install the sensor with the bolt.
      Fig 1: Identifying Crankshaft Position Sensor
      GTY102959Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the crankshaft position sensor connector.
  2. ADJUST COMPRESSOR OIL  . Refer to INSTALLATION - Step 1
  3. INSTALL COOLER COMPRESSOR ASSEMBLY (for 2WD)  . Refer to INSTALLATION - Step 2
  4. TEMPORARILY TIGHTEN COOLER COMPRESSOR ASSEMBLY (for 4WD)  . Refer to INSTALLATION - Step 2
  5. INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (for 4WD)  . Refer to INSTALLATION - Step 3
  6. INSTALL OIL FILTER BRACKET (for 4WD)  . Refer to INSTALLATION - Step 4
  7. TIGHTEN COOLER COMPRESSOR ASSEMBLY (for 4WD)  . Refer to INSTALLATION - Step 5
  8. CONNECT DISCHARGE HOSE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 3
  9. CONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE  . Refer to INSTALLATION - Step 4
  10. INSTALL V-RIBBED BELT  . Refer to INSTALLATION - Step 1
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. CHARGE REFRIGERANT  . Refer to REPLACEMENT - Step 2
  13. WARM UP ENGINE  . Refer to REPLACEMENT - Step 3
  14. INSPECT FOR LEAKAGE OF REFRIGERANT  . Refer to REPLACEMENT - Step 5
  15. INSTALL REAR ENGINE UNDER COVER LH (for 2WD) 
  16. INSTALL ENGINE UNDER COVER (for 4WD) 
  17. INSTALL ENGINE UNDER COVER (for 2WD) 
  18. INSTALL NO. 1 AIR CLEANER INLET  . Refer to INSTALLATION - Step 114
  19. INSTALL V-BANK COVER  . Refer to INSTALLATION - Step 132
  20. INSTALL COOL AIR INTAKE DUCT SEAL  . Refer to INSTALLATION - Step 135
  21. PERFORM INITIALIZATION 
    1. Perform initialization. Refer to INITIALIZATION .
      NOTE:

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

scientia non olet · About LEMON Manuals