Injector Driver: Installation: Installation

INSTALL INJECTOR DRIVER
NOTE:
- Be careful not to drop or strike the injector driver.
- The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.
1. Install the injector driver with the bolt and 2 nuts.
  
  Fig 1: Identifying Injector Driver Bolt And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
2. Connect the 4 injector driver connectors.
  
  Fig 2: View Of Moving Lock Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Connect the 3 connectors with wire harness locks and the connector to the injector driver. Move the lock lever in the direction indicated by the arrow to lock the connector.
    NOTE:
    Connect the connector securely.
INSTALL NO. 1 ENGINE COVER
1. Install the cover with the 2 cap nuts and clip.
  
  Fig 3: Identifying Clips And Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 AIR CLEANER INLET
1. Install the No. 1 air cleaner inlet with the bolt.
  
  Fig 4: Identifying No. 1 Air Cleaner Inlet And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
INSTALL COOL AIR INTAKE DUCT SEAL . Refer to INSTALLATION - Step 135
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization. Refer to INITIALIZATION .
  NOTE:
  Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.