Front Stabilizer Bar: Installation

1. Install the 2 front stabilizer bar bushings No. 1 to the outside of the bushing stopper on the front stabilizer bar.
   NOTE: Make sure that the cutout of the front stabilizer bar bushing No. 1 faces the rear side as shown in the illustration.

Fig 1: Installing Front No. 1 Stabilizer Bracket

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the front No. 1 stabilizer bracket LH.

1. Install the front No. 1 stabilizer bracket LH.

1. Install the front stabilizer bar with the 2 bolts. (LH Side)

   Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf) 

   Fig 2: Locating Front Stabilizer Bar LH Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the front stabilizer bar with the 2 bolts. (RH Side)

   Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf) 

   Fig 3: Locating Front Stabilizer Bar RH Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Refer to the instructions for installation of the engine assembly (See INSTALLATION ).

1. Install the front stabilizer link assembly LH with the 2 nuts.

   Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

   HINT:

   If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

   Fig 4: Locating Front Stabilizer Link Assembly LH Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the front stabilizer link assembly RH with the 2 nuts.

   Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

   HINT:

   If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

   Fig 5: Locating Front Stabilizer Link Assembly LH Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

(See ADJUSTMENT  )