LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> ES 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Ignition) >> Ignition Coil >> Removal

Ignition Coil: Removal

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  3. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  4. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  5. REMOVE FRONT SUSPENSION UPPER CENTER BRACE  (See REMOVAL )
  6. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  7. DRAIN ENGINE COOLANT  (See COOLANT )
  8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See ON-VEHICLE INSPECTION )
  9. REMOVE INTAKE AIR SURGE TANK ASSEMBLY  (See REMOVAL )
  10. REMOVE NO. 1 SURGE TANK STAY 
    1. Remove the bolt and disconnect the harness clamp.
      Fig 1: Locating Bolt And Harness Clamp
      G04975497Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and No. 1 surge tank stay.
      Fig 2: Locating Bolt And No. 1 Surge Tank Stay
      G04975498Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE IGNITION COIL ASSEMBLY 
    1. Disconnect the 6 ignition coil connectors.
    2. Remove the 6 bolts and 6 ignition coils.
      Fig 3: Locating Ignition Coils And Bolts
      G04975500Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals