Data List / Active Test

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

DATA LIST

Connect the intelligent tester to the DLC3.
HINT:

By accessing the DATA LIST displayed on the intelligent tester, it is possible to perform such functions as reading the values of switches and sensors without removing any parts. Reading the DATA LIST is the first step in troubleshooting and is one method to save diagnostic time.
Turn the engine switch on (IG) and turn the intelligent tester on.

Operate the intelligent tester according to the steps on the display and select DATA LIST.

Fig 1: Connecting Intelligent Tester To DLC3 Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

SMART:

DATA LIST

Tester Display	Measurement Item/Range	Normal Condition
SLCK SLEEP COND	Steering lock ECU sleep condition / YES or NO	YES: Steering lock ECU sleep mode can be entered NO: Steering lock ECU sleep mode cannot be entered
SLCK START COND	Steering lock ECU start signal / YES or NO	YES: Steering lock ECU sent a start signal NO: Steering lock ECU did not send a start signal
ENG START COND	Engine start condition / OK or NG	OK: Engine is allowed to start NG: Engine is not allowed to start
SENSOR VALUE	Sensor malfunction / NG (PAST) or OK	NG (PAST): Sensor malfunction OK: No malfunction
PWR SUPPLY SHRT	Short in ECU / NG (PAST) or OK	NG (PAST): Short in ECU OK: No malfunction
PWR SUPPLY OPEN	Open in ECU / NG (PAST) or OK	NG (PAST): Open in ECU OK: No malfunction
MTR DRIVER SHRT	Short in driver ECU / NG (PAST) or OK	NG (PAST): Short in driver ECU OK: No malfunction
MTR DRIVER OPEN	Open in driver ECU / NG (PAST) or OK	NG (PAST): Open in driver ECU OK: No malfunction
LCK/UNLCK REC	Steering lock command reception record / YES or NO	YES: Steering lock/ unlock signal received NO: Steering lock / unlock signal no received
LCK BAR STUCK	Lock bar stuck malfunction / NG (PAST) or OK	NG (PAST): Lock bar stuck malfunction OK: No malfunction
PUSH START ERR	Push button start function malfunction / NG (PAST) or OK	NG (PAST): Malfunction in push button start OK: No malfunction
IG2	IG2 voltage / ON or OFF	ON: 10 to 14 V OFF: Below 1 V
IG (LIN)	LIN bus IG status / ON or OFF	ON: LIN bus IG ON status OFF: LIN bus IG OFF status

ACTIVE TEST

Connect the intelligent tester to the DLC3.
HINT:

Performing the ACTIVE TEST is one of the methods to save diagnostic time. It is possible to display the DATA LIST during the ACTIVE TEST.
Turn the engine switch on (IG) and turn the intelligent tester on.

Following the display on the intelligent tester, perform the ACTIVE TEST.

Fig 2: Connecting Intelligent Tester To DLC3 Terminal

MAIN BODY:

DATA LIST

Tester Display	Test Part	Control Range	Diagnostic Note
STR LOCK PWR	Steering Lock Power Source	ON / OFF	-