Engine Hood Courtesy Switch: Installation

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HOOD LOCK ASSEMBLY
1. Apply MP grease to the sliding areas of the lock.
  
  Fig 1: Locating Grease Applying Area
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the hood lock control cable and connector.
  
  Fig 2: Connecting Hood Lock Control Cable And Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the hood lock assembly with the 2 bolts and nut.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 3: Identifying Hood Lock Assembly With Bolts And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install a new hood lock nut cap.
INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) ( INSTALLATION )
INSTALL FRONT BUMPER ASSEMBLY ( INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL ( INSTALLATION )
ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) ( REMOVAL )
VEHICLE PREPARATION FOR FOG LIGHT AIM ( REMOVAL )
PREPARATION FOR FOG LIGHT ( ADJUSTMENT )
FOG LIGHT AIMING INSPECTION ( ADJUSTMENT )
FOG LIGHT AIMING ADJUSTMENT ( ADJUSTMENT )